Protect Fast Cure
Fast Cure is a high-gloss coating based on a 2-component aliphatic polyaspartic.
Protect Fast Cure
Adapt your system
Your floor
Primer
Primer GW, 100 - 150 g/m²Coating layer
Coating Polyaspartic Coloured , ~ 300 g/m²2nd Coating layer
None: 250 - 300 g/m²Polyaspartique coloured: Coating Polyaspartic Coloured , ~ 300 g/m²
Topcoat
Satin gloss: Coating PU MG Satin Gloss, 125 - 150 g/m²Matt: Coating PU MG matt , 125 - 150 g/m²
Fast Cure is a high-gloss coating based on a 2-component aliphatic polyaspartic.
With the application of just one or two layers, you can quickly transform a floor into a modern, functional floor.
The floor is composed of two-component polyaspartic that can be applied with and without flakes. Despite the short curing time, the polyaspartic can be brushed on and rolled out of the bucket for a long time. The result is an almost indestructible, attractive floor available in fifteen attractive decorative flake mixes. The neutral colours are available in all RAL and NCS colours. Fast Cure has three variants: Coloured, Flake and Anti Skid.
Consult the Quartzline Protect Fast Cure sample book for examples and colours. Go to our webshop for this.
System explanation
The composition consists of two component polyaspartic that can be processed with and without flakes.
Fast Cure belongs to the EDS category of floors. EDS means that one layer needs approximately one hour of curing time. In half a day, the floor can be ready for use again. However, temperature and humidity play an important role.
It is recommended to apply the Fast Cure with two persons. One person to distribute and the other to roll over. With its very fast curing time, the floor can be walked on very quickly.
Always start with a layer of Primer GW. Once this layer has lost its moisture - which can be seen by its colouring from yellow to transparent - you can start applying the polyaspartic.
If you choose Coloured
The result is a non-fading high-gloss coating that can be applied in one or two layers.
If you choose Flake
A coating layer that is completely sprinkled with flakes. Then a transparent finish in two layers. To prevent a rough and sharp surface, it is important to sand the first topcoat and then apply a second topcoat.
If you choose Anti Skid
Then a non-slip floor is created by a coating layer sprinkled with quartz. With a second coating layer as extra protection of the sprinkling layer.
Matt or Satin Gloss?
If matt or satin gloss is preferred, overcoating with Quartzline Coating PU MG Matt or Quartzline Coating PU MG Satin Gloss offers the desired result. Applicable indoors only.
Ideal for:
- Automotive
- Restaurants
- Retail
Disclaimer
Despite the fact that this calculation system has been carefully compiled, no rights can be derived from the outcome. These calculations are performed on the basis of a number of general principles. The results of the calculations are only an indication. This is because the applicable circumstances for the project concerned for which the order applies cannot be taken into account.