PUCEM TF Instrooi-systeem
Polyurethane cement TF is an anti-slip (DIN) infill floor system for a thickness of 4-12 mm.
PUCEM TF Instrooi-systeem
Adapt your system
Your floor
Polyurethane cement TF is an anti-slip (DIN) infill floor system for a thickness of 4-12 mm.
The Eurostep PUCEM TF broadcast system is a 4-12 mm floor finish consisting of a combination of polyurethane and cement. The PUCEM TF broadcast system (broadcast material such as quartz sand) is often used in the industrial sector.
- The PUCEM TF roadcast system is wear-resistant and heavy-duty.
- The broadcast material provides anti-slip, making it safe to walk on wet floors.
- PUCEM TF is liquid-proof and highly resistant to chemicals, oils and solvents.
- The seamless finish also provides an easy-to-clean surface that is hygienic and meets the strictest food safety standards.
- Extremely heat resistant and can therefore withstand hot water.
- Rapid build-up of high strength in a short time
Summary
PUCEM TF broadcasr system is a robust, strong and decorative floor that is heavy duty and easy to clean. Suitable for industries such as factories, garages and workshops.
- For technical description see: TDS
- For optimal application of PUCEM TF infill system, please follow the instructions.
Pay special attention to this (the manual in a nutshell)!
1. Thoroughly clean and degrease the substrate. Do not apply the product if the floor temperature is below 15° Celsius.
2. (Diamond) sanding or blasting removes the cement residue.
3. Pour the A-component into a bucket and add the pigment paste.
4. Then add the entire contents of the B component to the A component and pigment.
5. Mix for 30 seconds until a homogeneous mixture is formed.
6. Add the filler and mix thoroughly for 1 minute until a lump-free mixture is formed.
7. Pour out the mixture and spread it evenly over the subfloor with Tooth Strip 28cm, 4700-280-S 10. Let it flow for about 10 minutes before you start spreading. Always pour the entire contents of the bucket at once to prevent rapid reaction of material in the bucket.
8. Depending on the desired slip level, sprinkle full and saturate with 0.4 - 0.8 mm or 0.8 - 1.2 mm quartz.
9. When the PUCEM TF has been applied, the floor should cure for about 10 hours.
10. Remove excess quartz from the floor and resand with a rotary parquet sander if necessary. ALWAYS finish the floor with PUCEM L
Ideal for:
- Food industry
- Chemical industry
- Pharmaceutical industry
- Dairy industry
- Commercial kitchen
- Bottling lines
Disclaimer
Despite the fact that this calculation system has been carefully compiled, no rights can be derived from the outcome. These calculations are performed on the basis of a number of general principles. The results of the calculations are only an indication. This is because the applicable circumstances for the project concerned for which the order applies cannot be taken into account.